Fibaro Smoke Sensor

The Fibaro Smoke Sensor is a universal, optical Z-Wave smoke sensor. The device can be hard wired (12 or 24 VDC) or battery operated (battery life 3 years*).

Smoke detection is signaled through siren and LED diode blinking. Additionally, the smoke sensor signal can be sent to an alarm system or fire alarm system hub, through a NC (normally closed) contact terminals.

The optical sensor detects smoke at an early stage of fire, often before flames appear and temperature starts to rise significantly. This device has a built-in temperature sensor, which can also trigger the alarm once the specified temperatute threshold is exceeded.

The Fibaro Smoke Sensor is designed to be placed on a wall or ceiling. LED indicator signals fire, operating mode and can be used to see if the device is within the Z-Wave network.

The smoke sensor is designed to operate in confined spaces, under normal conditions (lacking smoke, dust, condensed water vapor).

* Depending on the parameters settings.

This sensor cannot be used as the Primary smoke sensor in a dwelling.

Contact us for a supply & installed quote

• Compatible with any Z-Wave Controller.
• May be connected to any alarm or fire prevention system by hard wiring NC output
• Extremely easy installation – simply install it in location prone to fire.
• Battery or VDC powered.
• Built-in tamper switch.
• Alarm is signaled by sound and LED diode.
• Fire detection through air temperature measuring.
• Can trigger alarm just by exceeding temperature threshold.
• 3 levels of sensors sensitivity.
• Automatic efficiency test performed every 5 seconds.
• Built-in “black box” allows the device to report and record smoke and temperature readouts.

Z‐wave device type: Smoke Sensor FGSS-001 v2.3

Battery Type: CR123A

Dimensions: (W x H) 65 x 28 mm

Housing: ABS

RF Frequency: 921.42Mhz ‐ AU/NZ approved RF for Z‐wave

Power Consumption: 0.4w

Voltage: 3.6V

Operating Temperature range: 0C to 50C

Measured Temperature range: 0.5C (within 0C – 40C range)